44734:
sv: sv: Swivel pin preload - hvilke værdi. (28-03-2007 15:36:13) (svar på
44732)
Patrick O Schmith #7646, reg. nsj (medlem) (
ip-adr: 195.212.29.75)
Nemlig :
The scale should read somewhere between 5,5 and 7,3 kg resistance to pull the swivel housing all the way over from lock to lock.
Og i workshop manual :
Swivel pin preload setting
1. The swivel pin preload setting must be checked
and set See FRONT AXLE AND FINAL DRIVE,
Overhaul, Front Stub Axle, Constant Velocity
Joint and Swivel Pin Housing .
Note that a pull load of 1.16 - 1.46 kg is required
after the axle shaft and swivel housing seal have
been removed.
OK, der måles på forskellig måde.
Tak
Patrick